Plastic Adhesive - Soft Light

Plastic Adhesive - Soft Light

Indicated for correcting imperfections in automobile body parts, gutters, metallic parts, glass fiber and furniture.

It may also be used to glue or correct imperfections on marble and granite.

SURFACE PREPARATION

Sand with 80 or 150 grit sanding sheet. Then, clean the part with Maxi Rubber Degreasing Solution.


APPLICATION

• Homogenize the Adhesive before its application.

• Remove the desired quantity and put it onto a clean and plane surface.

• Remove the desired quantity and put it onto a clean and plane surface.

• Add 1 gram of the Pasty Catalyst for every 100 grams of adhesive.

• Mix it well until you obtain a homogeneous mass.

OBS.: The time spent from the mixture of the adhesive with the catalyst to its application should not exceed 3 to 5 minutes.

• Apply the catalyzed adhesive using an applicator (celluloid) in thin layers until the defect is corrected.


DRYING

• Drying for sanding – 25ºC: 60 to 120 minutes.


SANDING

• After the drying, perform the sanding with dry sanding sheet (80 - 150 grit sanding sheetsand final with 220 - 320 grit sanding sheets).

• The product should be applied directly over a bare sheet.

• In the mass (catalysis) preparation, use the correct quantity of catalyst 1%, thus avoiding bleeding problems.

• Do not replace the mixture already prepared into the can.

• Wait for the recommended drying time, in order to prevent lapping.

• Avoid forced drying at high temperatures, because it may cause cracking, blistering and loss of adhesion.

• Wet sanding of the adhesive is not recommended, because the humidity retained in the adhesiveduring the sanding with water may cause problems on the surface and finishing.

• Isolate the repair location with Primer PU Maxi Rubber before applying the finishing.


Packing
  • 500g packed with 9g catalyst
Shelf life

1 year. Stored at a temperature of 15 to 35ºC and away from humidity.

Yield
  • 0,59 m²/kg
Composition

Adhesive: Mineral loads, pigments, additives and modified polyester resin. Catalyst: benzoyl peroxide and plasticizers.

São Paulo +55 (11) 4092-7777
Others States 0800 777 0 777